Show/Hide Toolbars

MaxxECU online help

Radiator fan control

 

Start temperature

Specifies the temperature when fan will be activated.

 

Hysteresis

Specifies the fan hysteresis. Uses to prevent unnecessary on/off. Normal value is 2 deg C.

 

Disable above speed

Disable FAN output above the specified vehicle speed (if a speedsensor is mounted and configured).

 

Run fan on ac

Specifies whether to run the FAN output when AC is active.

 

 

post shutdown cooling (requires ECU power hold relay)

 

Post key cooldown

Enable or disable the power hold relay feature to drive the coolant fan. External relay must be wired for this functionality, see power hold relay wirings.

 

Note: Engine FAN output is an on/off output used in combination with relay.

 

 

Examples

 

Example: Single FAN output

clip0560

An output assigned as Engine FAN which will activate the output at 86 deg C coolant temp (CLT), and stops the fan output at 84 deg C and will not run the output if AC gets activated.

 

 

Example: Two different fans wired to vehicle, low and high fan outputs.

clip0561

The engine fan output wired to the low fan, which will start at 80 deg C with 4 deg C hysteresis.

 

clip0562

Activate an USER output (where the high fan is wired) and make settings like the above which will start the second fan at 96 deg C and when engines cools down below 96 deg C it will continue to run the fan for 12 more seconds before shutting it off.

 

 

Example: automatic start of fan + button to force activation

clip0563

In the above example, the fan output will be activated when cooltant temp (CLT) is over 80 deg C OR if the digital input 1 is activated, (this can ofcource also be a MDash switch).