The 8HP control is not yet released, we are currently in BETA stage, but will be included in the next MTune 1.150 update in april 2024. Please be patient. Info pages are not yet completed and will be updated.
Dodge 8hp
Dodge 8HP Engine Torque
Transmitted from the MaxxECU to the TCU, -500 to 1547Nm.
Dodge 8HP Transbrake
Received from the TCU, 0=Not active;1=Active, cond. not correct;2=Active, cond. correct;3=Applied;4=Cancelled;
Dodge 8HP Torque Reduction Target
Received from the TCU, indicates the amount for torque reduction request, -500 to 1547Nm.
Dodge 8HP Target Gear
Received from the TCU, indicates the target gear, updated right before a shift indication.
Dodge 8HP Last Shift Time
Received from the TCU, indicates the last shifttime in milliseconds, this time indicates when the TCU starts to shift, and whne everything is seated and the TCU considers the shift is properly done.
Dodge 8HP Converter Lockup
Received from the TCU, 0=Starts to open;1=Open;2=Slip;3=Closed";
Dodge 8HP Driveshaft
Received from the TCU, filtered output shaft speed.
Dodge 8HP Driveshaft (UNFILTERED)
Received from the TCU, unfiltered output shaft speed.
Dodge 8HP Paddle Status
Received from the TCU, 0=Not engaged;1=Up;2=Down;3=Both;
Dodge 8HP Gearbox Mode
Received from the TCU, 0=Park;1=Reverse;2=Neutral;4=Drive;5=Manual;
Dodge 8HP Torque Reduction Request
Received from the TCU, 0=Disabled;1=Enabled;
Dodge 8HP Drive Mode
Received from the TCU, 0=NOT_SET;1=STREET;3=SPORT;5=TRACK;10=DRAG;
Dodge 8HP Limp Home Mode
Received from the TCU, 0=All OK;1=Activated, Limp Home;
Dodge 8HP idle speed request
Received from the TCU, indicates the idle speed the TCU wants, you don't need to use this value, it is just there 500 to 1516rpm.
Dodge 8HP Temp warning
Received from the TCU, 0=NONE;1=Excessive trans temp;2=Converter Temp;
Dodge 8HP Torque ctrl mode req
Received from the TCU, 0=NONE;1=TRQ_INC_FAST;2=TRQ_DEC_FAST;
Dodge 8HP trans warning
Received from the TCU, indicates if the TCU has some stored warnings.
Dodge 8HP Trans fault
Received from the TCU, indicates if the TCU has some internal faults, this should be 0 if everything is good.
Dodge 8HP Selector Switch
Received from the TCU, 0=Park;1=Reverse;2=Neutral;4=Drive;8=Manual;16=Manual+;32=Manual-;
Dodge 8HP Shift Status
Received from the TCU, 0=Not active;1=Active;2=Active, Up;3=Active, Down;
Gearbox oil temp
Received from the TCU, -20 to 140 deg C.
External TCU Calibration Version
Received from the TCU, to determine support.
External TCU Code checksum
Received from the TCU, to determine support.
External TCU Calibration checksum
Received from the TCU, to determine support.
External TCU Calibration ID
Received from the TCU, to determine support.
